New wiring for our ‘67 B’cuda
Loganscuda, the attached photo is an example. These wires are located on the under hood harness in the area the regulator and ballast resistor are, but I don’t have a photo to help guide me.
Using wire lengths as a guide, I can figure out where to mount the regulator. Using schematics, I see the green wire attached to the FLD post on the regulator.
1. Does the single blue wire connect to the other post?
2. Does the blue & blue with white stripe connect to the “input” side of the ballast resistor?
3. Does the brown and blue connect to the “outlet” side of the ballast resistor?
These are my questions at this time. All could have been answered if the wires were labeled, or had I started with an unmolested electrical system.
All help is appreciated.
Loganscuda, the attached photo is an example. These wires are located on the under hood harness in the area the regulator and ballast resistor are, but I don’t have a photo to help guide me.
Using wire lengths as a guide, I can figure out where to mount the regulator. Using schematics, I see the green wire attached to the FLD post on the regulator.
1. Does the single blue wire connect to the other post?
2. Does the blue & blue with white stripe connect to the “input” side of the ballast resistor?
3. Does the brown and blue connect to the “outlet” side of the ballast resistor?
These are my questions at this time. All could have been answered if the wires were labeled, or had I started with an unmolested electrical system.
All help is appreciated.
