Thermoquad - Lokar kickdown

The metal plate was simple .060 (IIRC) picked up from the local hardware store. The throttle lever arm is approximately the same length top to bottom as would any Chrysler Holley/AFB carb adapter.

The TQ has two holes drilled into the throttle arm lever. Do the same rod the metal plate. The throttle cable stud is one hole as seen. The second hole, use a small bolt and nut, washers/lock washer optional rod the smaller hole. Not the plate will not rotate.

The adapter plate for the throttle arm has a “Tail” that hangs low. Going pretty much straight down. This lower hole is for the Lokar transmission cable. It’s distance is approximately the same distance away from the throttle cable arm as the common adapter is.

You may find a minor issue with the Lokar horizontal adjustment screw.