1964 Dart Grüne Hölle Road Course/Track Day/AutoX Project
12/29/16:
Here's What I have accomplished since Last Post..
Rear Window Channel / Pinch weld area is all done with no more holes etc.
Finished with few coats of POR-15 in Satin Black.
Also Removed all of the Paint from the Sheet metal around the Trunk Lid. Plans include to Put a Tape Line under the top of the quarter Panel Seam and Paint This Area Semi Gloss Black..
I didn't spend as much time making the inside of this area Look Good as when the Window / Gasket and Reveal Molding are installed no one will ever see it.
The area Below the Taillight Buckets and Behind the Bumper trim moldings were gone - Will be rebuilding those from Scratch and burning in some steel - No Bondo for me.
Windshield Pinch Weld area is Rebuilt where needed, but when cleaning up I found an area under the lead where there was no steel and lots of holes in the cowl... so another Patch will go in there.
Plans include taking 2 bumpers to make one good one..The Bumper from the car is twisted and Bent alot - Foreground - The farm fresh one in the back is good for a paint job, but one corner has no steel in it... so I will cut a spot out of the bent one and weld it in the holey one.. The chrome is there but no steel behind it.
That's it for now.
Future plans include a new headliner, sail panel boards, etc, before putting windshields back in.
Then Getting to the metal work in the Rear bumper area and Grafting 2 bumpers into one.
Greg