[Found!] Small block P/S brackets

-
Status
Not open for further replies.
Dano, What pump…. Boy am I dumb… it’s about to get worse when I say IDK. Picture below.

Kim, it’s a ‘91 Dodge Ram 150 I’m tinkering with. But I’ll use any pump and bracket. The factory bracket does not hold the same angle.

65762B57-294A-45FB-A30D-4FA55C1DA053.jpeg
FC02AF9A-876E-4C62-8BF8-6E985B8FD553.jpeg
 
Thank you Dano. Will Colorado’s brackets fit/work?
 
dano said:
I take it yours hits the frame rail when you try to tighten the belt?
]
Click to expand...
I actually haven’t tried it yet. I’ve been busy on the exhaust. The issue is the angle of the P/S pulley in relation to the WP/crank.

This is also a A/C truck. It’s black/blue interior in Florida, so it needs it! LOL I don’t have the compressor, I’ll have to figure that crap out later. First things first, engine running. P/S pump now, Gas tank/fuel system next.
3942A94C-FB17-4656-AD7F-673631C51C98.jpeg
 
I know I have one of them I took it off a 86 318 truck. I'll let you know if I can find it.
 
Pretty sure all the pumps were Saginaw by the early 80s.

FWIW, I THINK any 70s to 90-ish 318 or 360 (or V6) van with V-belts would use the same pump, pulley, and brackets.
 
Status
Not open for further replies.
-

Back
Top