1964-66 A body Gen 3 motor mounts

crawsfire said
Been reading a lot but still can't come up with a solution for motor mounts. Is everyone making their own mounts.? Seems from older threads some outfit used to make them but no longer does.
I'm building a 66 barracuda using a 2007 5.7 with a Ford T56 Magnum on 17" magnum 500s. Using SRT 300C manifolds, Mcleod 10.5" flywheel, Holley pan, Mopar performance intake and throttle body with their stand alone harness and a tanks inc. efi fuel tank/pump. I still need to source a radiator
and decide which bellhousing I want to go with. Seems like quicktime is the only outfit that has a gen 3 to ford t56 bell. Once I figure that out I'll need to figure out the throw out bearing. Any input is much appreciated. Thanks!

Gen3 Mounts have never been available for the first of Abodies.
I have just built a set of mounts for my 62 lancer 6.4 swap. After making a cardboard model, and actually bolting them in place. I was able to cut the pieces from 3/16 plate and weld them together. I used rubber mount insolators, (part #2265) in between the brackets and pad.