Accessory mounting issues on new intake
Hey guys. Ran into another issue while moving accessories and brackets from my LA with Performer onto my Magnum with Assault and looking for ideas. I am mounting my factory AC onto the intake and the bracket winds up directly over the outlet for the heater line. On my LA the heater line is on the other side of the thermostat. I could notch out the AC bracket but then there is the throttle return bracket that winds up right above it also. I guess I could modify that as well. There is a coolant plug on the new manifold same place as the LA and there is plenty of room but the diameter is much smaller. Would be great if I could use brass fittings and step out to the heater hose diameter which is 1/2". Not sure if this even matters for a heater hose. Hopefully the pictures show what I am describing.
Please.....no comments on my intake choice. Water under the bridge. Thanks.
NOTE: Magnum pictures are upside down. AC mount and heater line are on driver's side.
Thanks.
Hey guys. Ran into another issue while moving accessories and brackets from my LA with Performer onto my Magnum with Assault and looking for ideas. I am mounting my factory AC onto the intake and the bracket winds up directly over the outlet for the heater line. On my LA the heater line is on the other side of the thermostat. I could notch out the AC bracket but then there is the throttle return bracket that winds up right above it also. I guess I could modify that as well. There is a coolant plug on the new manifold same place as the LA and there is plenty of room but the diameter is much smaller. Would be great if I could use brass fittings and step out to the heater hose diameter which is 1/2". Not sure if this even matters for a heater hose. Hopefully the pictures show what I am describing.
Please.....no comments on my intake choice. Water under the bridge. Thanks.
NOTE: Magnum pictures are upside down. AC mount and heater line are on driver's side.
Thanks.
