This is what's left as of this evening. I am putting the lower back edge of the lip where it needs to be, and trimmed the excess above it. Note the green mark by the 3/8" wood block is now lined back up. I trimmed the excess above it. The 3 square bumped out pads on the outer wheel houses located front, rear, and top center are where padded clamps are put at the factory to hold the quarter skin in position tightly against the wheel house for welding. This is why I am making sure to keep these while reworking the wheel arch. So far so good. I think once it's got primer on it, nobody will ever know this has been moved, and the skin will fit like a glove in this area. After this its onto the front to fix another spot where it fits like dogshit.
View attachment 1715900175
View attachment 1715900176
View attachment 1715900177
