loose bearing race - K/H disc hub

my68barracuda said

and me , just a Professional Engineer with over 42 years experience in automotive casting-machining, engine assembly and engine test.
Also did I mention, ASQ Certified Quality Auditor and Six Sigma Black Belt certifications.
I think I know a little about: parts, problem identification and problem resolution.

Click to expand...

One thing not considered by all the geniuses using this loctite is: since the OP stated the race is tight going in and becomes loose when seated. How would you get a uniform coat while holding the race centered. Stand it up and it flows to one side. Lay it down which would be how you would install the race and it flows out the back while installing.

I guess if your a black belt you could Karate chop it in there. LMFAO. I don't care how many belts you have . And your engineering degree must have been mail ordered. Put that in your Crack pipe and smoke it. Richard Cranium