Yea. Those are rubber couplers on there with room in between the rad and the tubeWith those solid tubes going to radiator, will there be enough flex to keep from breaking the radiator?
Yea. Those are rubber couplers on there with room in between the rad and the tube
It should be flexible enough. There will be a front to back limiter and a torque limiter on the engineI see that, but they're not very long. I know it all depends on engine movement. And how soft the couplers are. Just hope it has enough flex.
Nice project!
Eh. It sure yet. I’ll be able to run a very small old school dome screen it looks likeWill the flat hood clear that intake/throttle body setup?
I made my own out of .250 steel. I used tti website dimensions. Slant 6 member so I had to make my ownWhat are you using for motor mounts?
Go on trans dapt website. It’s for a m22 thread forgot parts number at the moment. Works out well better than the ones coming out the side of the block in my opinionWhat oil filter relocate kit did you use?
It’s tight but you’ll be happy you did! Side exit doesn’t work well with alternator right there..I've been eye balling that. We did the fittings out the side, that gets really tight. I never gave a thought to mounting the filter like you did. I now know what I need to do!
Question for you. What's holding in the passenger side water tube in, in this picture? You cut it pretty short and not using the stock tube mount mid block. It was and o-ring fitting, did you tap the housing?
Welded a tab to tube and drilled and tapped 1/4-20 into water pump. Perfect spot for it.Question for you. What's holding in the passenger side water tube in, in this picture? You cut it pretty short and not using the stock tube mount mid block. It was and o-ring fitting, did you tap the housing?
Way to make it happen! Progress looks fantastic!Making progress on the headers. Have one more to go. Also have some track hawk injectors for it now. Ordered a hellcat 525 walboro pump. Going to do some e85.View attachment 1715898431View attachment 1715898432View attachment 1715898433View attachment 1715898434View attachment 1715898435View attachment 1715898436View attachment 1715898437View attachment 1715898438
I made my own out of .250 steel. I used tti website dimensions. Slant 6 member so I had to make my own
Go on tti website. It’s under the hemi swap headers for A bodyDo you have a link for those dimensions? Can’t find them… just picked up a BGE 6.4 today for my ‘70 dart. Was planning on making my own mounts too, got a slant 6 K frame as well.
Looking awesome! Will definitely be watching!
Mike
Agree. They seem a touch different that any straight through muffler. Quality is top notch also.Nice I’ve got borla XS mufflers on my 65 Dart 273 I like it sounds little different than everything else.