100 shot of nitrous on 360 magnum engine

Bakerlite said
A lot of people are making some good points here for safety and tuning etc..
Having said that, when I installed my first kit back in the 80's , all I bought was the adjustable kit, a Holley blue, some wire, a micro switch for the carb, an arming switch, points switch and relay and a twin point dizzy conversion plate so I could switch between one set of points to the other to retard the timing. Plus a spare pair of underpants.

Had lots of fun in the 80's with a pin vise and 61-80 bits drilling out spray bars in the low HP kits that weren't adjustable!

I remember BB Chevies with the edelbrock canted carb base victor 2R and Torker were a total ***** because some of the holes sprayed right down 4 runners and the other 4 weren't as well lined up, as in not at all. Distribution issues galore. Ended up putting a 2" spacer, then the plate on top. Like a tunnel ram height intake. LOL

This PIA...

1,3,6&8 run like a ****!!!