I see adds for hood scoops with adhesive to hold them to the hood. anybody tried this method? I have my doubts . Thanks
Hood scoop
- Thread starter Roadart
- Start date
-
In the search box type in adhesive hood scoop. There's some opinions about just that.
You could do that . But I would call in the Gorilla and have him go over it .
Sounds like a stupid idea to me. You could use some body panel adhesive and it would be permanent. Although the cost of that stuff would be able the same as if you did it the correct way.
I am a bit surprised,some say it works good. Did not want to put holes in the hood. Thanks for your ideas.
JB weld
Elmer's glue.
diymirage
HP@idle > hondaHP@redline
Then what is the point of the scoop?
Yote
Well-Known Member
Hope it doesn’t become a ‘windshield scoop’. lol
You will probably be ok, but some adhesives ‘dry out’ after a few years and are prone to releasing.
Yote
You will probably be ok, but some adhesives ‘dry out’ after a few years and are prone to releasing.
Yote
The cars look real nice without the scoops too.
Clean flow, your eyes folllow the stylish Body Lines.
Clean flow, your eyes folllow the stylish Body Lines.
Confirm the color, Winchester grey? Also spend the money on factory all black Twister scoops and a ladder stripe. That is a nice looking car it deserves a factory hood treatment not glue on scoops.
Either one would look good.
I had a Demon Sizzler that color.
Either one would look good.
I had a Demon Sizzler that color.
Last edited:
If my last Duster would have been that color factory it would still be here.
-
