intake gasket is sweating coolant?

71DodgeDemon340 said
correct no dowl pins on the china walls and used rtv to seal them. Im running the edelbrock performer rpm heads. Didnt dry fit the manifold. Everything looked to be good but did not run a straight edge along the china walls or heads or intake. All corners were sealed before just had coolant leaking from the pass side front intake bolt which is why i changed the gaskets.

Oh! What did you use to seal the bolts? Not sure if the manifold bolts go into water or not, but if so you might need some plumber's dope on them. I seem to remember suffering a leaky bolt once too, and that was my solution. Can't remember if it was the manifold or a water pump bolt, but it leaked twice after trying to seal with RTV. The pipe dope fixed it good.