So what's everyone doing for camshafts these days?

Like the thread title states--I am trying to slap together a decent 450hp 360 based off of a 5.9 Magnum I have here. This build is a stop gap build just to get my truck up and moving. Looking for some SCAT I-beams--NADA ZILCH anywhere... Ok so I want to use a hydraulic roller cam and try some "things" with the lifters. I want something decent with somewhere between 230-246 @ .050" duration-decent lobe lift and at this point I don't care about the LSA. I have searched ALL my vendors and the only stock is hydraulic flat junk, or really mild basically stock hydraulic rollers. So I check Summit--same deal, check E-Bag same , Call Hughes and ask Glenn I believe his name was , asked him right away what cams he had in stock for small block--he says ZERO and have 100+ on B.O. Goes on to tell me that their supplier hasn't had cam cores since November and they don't have a clue when the next order will come in--great! As a side note I called Mahle for a set of SBC pistons--nothing special and was told 16 week wait!! I thank the good lord for such a good job--I'd be homeless by now if I had to rely on this thankless trade for my main income. So does anyone have a used or unused cam sitting on their shelf for sale? Good rods? EQ heads with LA bolt pattern? I have everything else to get this project off the ground and would like to create a thread considering I am dying to use my TR and modded carbs. If the camshaft was hairy enough I might even target 500HP. Our evil overlords have done such a fine job of crushing the economy and marching us towards complete enslavement. I really enjoy paying 2X, 3X even 4X for just about everything while.... Sorry for getting off topic. Just need a few parts. J.Rob