Cant get this to run, need help

Stupid question. Is the two wire plug from the distributer connected to the harness? If yes, make sure the battery is charged up, recheck the voltage at the coil + (it should be more then 5 volts with ign sw on, but not cranking). If voltage is around 8 volts (or higher), connect test light to coil (-), and crank engine. Test light should "blink" on and off. That will tell you if the dist is sending a signal to the module and the module to the coil. If the test light does not blink, it could be a bad module, or bad pickup in the dist.