Raised Port Head Question
Yes sir, with a lot of help from FABO and friends. Clearanced the rockers with a ball end mill to keep the radius. Clearances for a 3/8 pushrod with sanding drums, Measured for new pushrods (after making a solid lifter with washers) and checked PV clearance with that same solid lifter. Everything is spinning over by hand now and looks good. Finally torqued everything down with cometic gaskets. Engine is back in the car, working on wiring it all and hopefully fire it in the next month or two.
Yes sir, with a lot of help from FABO and friends. Clearanced the rockers with a ball end mill to keep the radius. Clearances for a 3/8 pushrod with sanding drums, Measured for new pushrods (after making a solid lifter with washers) and checked PV clearance with that same solid lifter. Everything is spinning over by hand now and looks good. Finally torqued everything down with cometic gaskets. Engine is back in the car, working on wiring it all and hopefully fire it in the next month or two.
