wiggle of the starting line.

Well as i said more question then answer.
The tie rod is in a down hill rack(as i thought it would be) but as the suspension goes up(floor jack under the K frame) the tie rod becomes even steeper in its angle not, not less as the suspension goes up as i had thought. Spindle tie rod end down or lower then center link bar end of tie rods

However, the toe is at 0 (or as close as i can tell with a 2x4 and a tap measure) at ride height. Jack up until one tire unloads enough to start to slide inward. measure again, and it is toe out 3/8 of a inch.

So this is what don't make sence to me. as the tie rod goes down it becomes shorter in length horizontal. So, in my mind it should toe in as the suspension goes up. BUT it did not, it toe out.
EDIT: I have to keep reminding my self that the tie rod is on the back side.
Shorter would cause it to toe out.:BangHead:

I'm not a suspension guy at all but i don't think this is my problem with it swinging the *** end out to the left at launch.