3D Prints of Hood and Door Bumper Stops with TPU 95A
Middle print shows what happens if print does not have correct orientation on build plate. Tried to print model bird whistle found on Thingiverse. When the mouth piece started looking like spaghetti, print was stopped. I figured out what went wrong, shrank part to 75%, tried again. Correct orientation shown or right. It worked, so reprinted in blue full size.
I learned that paying attention to slicer preview is important. It is possible to zoom in and see what print head is doing on each layer.
Slicers have tool for scaling, mirror, orientation, and multiple parts on build plate. I am just starting to learn about all that.
Middle print shows what happens if print does not have correct orientation on build plate. Tried to print model bird whistle found on Thingiverse. When the mouth piece started looking like spaghetti, print was stopped. I figured out what went wrong, shrank part to 75%, tried again. Correct orientation shown or right. It worked, so reprinted in blue full size.
I learned that paying attention to slicer preview is important. It is possible to zoom in and see what print head is doing on each layer.
Slicers have tool for scaling, mirror, orientation, and multiple parts on build plate. I am just starting to learn about all that.
