Window tint (not an A)

Thise windows look pretty flat which helps. Here's how I did it long ago when I was doing it regularly. I even did all windows in a house.

Spray bottle with water and a little Dawn.

Clean windows with spray and scrape windows with a razor blade.

I cut the sheet maybe 2" bigger all sides.

Then I used two pieces of tape facing each other over one corner of the sheet of tint to get the backing separated from the tint. Hope that makes sense.

As you are separating the back, spray the tint with the water/dawn solution. Keep it dripping wet or it will stick to anything it touches. Spray down the window also.

Then i slid the bottom center down past the cat whiskers making cuts on the sides to fit. I slid it down a good inch or so.

Start from the center and squeegee out the water. Once the water is gone, it will stick.

Use a very sharp blade and change it after each window.