'69 Valiant 2DR Project
Worked on the hot side until I ran out of argon. After that I designed and 3D printed an adapter to run the Jeep 4.0 cam sync sensor. I’ll get one turned out of aluminum next as the 3D print won’t hold up to under hood temps.
I’m going to rework the exhaust a little as I’m not happy how they’re sitting right now. There a little too close to where the rad/fans/shroud is going to be.
I also ordered injector bungs and a Chinese airgap intake to practice on, as I’d like to try and drill/weld for the injector bungs myself. They should be here Monday so I may be able to try that out next week.
Worked on the hot side until I ran out of argon. After that I designed and 3D printed an adapter to run the Jeep 4.0 cam sync sensor. I’ll get one turned out of aluminum next as the 3D print won’t hold up to under hood temps.
I’m going to rework the exhaust a little as I’m not happy how they’re sitting right now. There a little too close to where the rad/fans/shroud is going to be.
I also ordered injector bungs and a Chinese airgap intake to practice on, as I’d like to try and drill/weld for the injector bungs myself. They should be here Monday so I may be able to try that out next week.
