Time to unveil "Project Blackstone"
Updates: Almost all hardware is in...the wiring for testing the servo is complete. The models are finished (I think lol), the bottom/back panel is printed with the servo mounted, currently printing the Right panel, which is also connected to the top panel as all one piece. Almost done with that one, then the left panel will be printed. I ran a print of the radio bracket again, this time at an angle to minimize the amount of supports used, but that cause other issues. I have a useable test piece from it, but it's not pretty in a couple of spots. Will reprint that after all the other printing is done. More updates tomorrow or monday, hopefully a video of it in action.
Updates: Almost all hardware is in...the wiring for testing the servo is complete. The models are finished (I think lol), the bottom/back panel is printed with the servo mounted, currently printing the Right panel, which is also connected to the top panel as all one piece. Almost done with that one, then the left panel will be printed. I ran a print of the radio bracket again, this time at an angle to minimize the amount of supports used, but that cause other issues. I have a useable test piece from it, but it's not pretty in a couple of spots. Will reprint that after all the other printing is done. More updates tomorrow or monday, hopefully a video of it in action.
