[WANTED] 68 Barracuda Rocker Trim

-
Status
Not open for further replies.
Steve Kranz

Steve Kranz

Member
Joined
Nov 6, 2020
Messages
10
Reaction score
0
Location
Port Ludlow WA
Rating - 0%
0   0   0
Contact seller
Looking for a rocker molding piece for my 68 Cuda. The contour is asymmetrical and appears to match the end of the cast "gill' piece that forward of the rear wheel well. Not sure, but is this a '68 only piece? I have one uncut full length piece and it appears to be used on either side. Car did not come with gills, so I will have to cut to the appropriate length. I've attached pictures of the one piece I have. Need to find another. Any info you can provide on this would be greatly appreciated Thanks!

0720221429.jpg
0720221429c.jpg
0720221429b.jpg
0720221429a.jpg
0720221429.jpg
 
And they are side specific. And the correct clips to mount are not available, to my knowledge.
 
They are left and right and 1968 only. Symmetrical spears that reach wheel opening to wheel opening are 1967. Do not cut asymmetrical spears, they are too rare! If you cannot use the extra spear I will buy. I have an extra pair of gills. Spears are "open" on one end to slip into the gill.
 
No one is making them.
The E body rear clips are the correct size just a little wider. Wider is okay the height is the exact size.
68original said:
Did someone start repopping clips? I gave up looking, could never find right ones.
Click to expand...
 
Status
Not open for further replies.
-

Back
Top