Plug read, opinions needed
If you don’t have a redneck lathe you need one.
plug chucked in a drill press and a cutter clamped in to a vise. Works like a champ. Takes about 2 minutes to cut the hex off the plug and the ceramic falls out.
looks like my fuel ring is right at .105 wide. I call that ever so slightly rich but because this is on boost, I’m happy with it. To correlate that to a number this pull was 11.8-12.1 from 3500-6200 on a gas scale.
now I just have to cut 7 more.
If you don’t have a redneck lathe you need one.
plug chucked in a drill press and a cutter clamped in to a vise. Works like a champ. Takes about 2 minutes to cut the hex off the plug and the ceramic falls out.
looks like my fuel ring is right at .105 wide. I call that ever so slightly rich but because this is on boost, I’m happy with it. To correlate that to a number this pull was 11.8-12.1 from 3500-6200 on a gas scale.
now I just have to cut 7 more.