Not an A but still barely a Mopar...'12 Caravan lock actuator fail...

Once again...THIS JOB SUCKS! Got the new one in after soccer got cancelled today. Few more tips. There are 2 bolts holding the rear track in, make sure you get both and NOT the rounded bolt under the hinge, That is not for the track. If you decide to do this without removing the window (some won't want to remove that $85 trim and surely break its anchors in the process) when you are putting the SUB assembly (unclipped from the inner door panel) back into the door, you must push the track up into the window channel to clear the bottom inner door brace. I tried about 3 times before I realized there was no way I could get this latch assemble in without going over this brace and then a steady push up (your going to be dragging against the window)clears it and it slid right in. I think this was my big issue last time I was putting this together. That is why the track is only supported in the bottom and is free to pivot on the sub assembly or else there wold be no way to get it up in the channel. Last hurdle was getting the new style clip on the replacement actuators to clip over the lock lever rod. There is very little room in there to rotate the clip up and lock it onto the rod. I had to position a screwdriver under it and push it up from the bottom and then slide the inner panel over this in-place rod. Wear long sleeves are there are lots of sharp edges in there. Have a good time! I'm NOT looking forward to the other one failing......