sleeving 8 3/4 bearing housing???
I've got a nice A-body 8 3/4 housing that at some point spun an axle bearing. The area where the bearing race would sit is boogered up, bit not horribly. Is there a sleeve for this so that it could be machined and sleeved without compromising the strength?
I've got a nice A-body 8 3/4 housing that at some point spun an axle bearing. The area where the bearing race would sit is boogered up, bit not horribly. Is there a sleeve for this so that it could be machined and sleeved without compromising the strength?
