New Tool from Bad Cam

Well, happy to report that I did this myself and it's working well now. However, I think my block had some shift or something because it was very tight. It wasn't a matter of a few turns. I had to tap the cam in with a hammer, make a few turns, tap again, turn, repeat. Remove cam to take out shavings, and clean, and repeat. Then when it would finally at least go in and spin fairly freely I started test fitting the real cam. Still tight. Tried the "few turns method" and it wasn't really going anywhere. So I ended up spinning it with a drill on the cam bolt, sliding the cam back and forth across the full face of the bearings whilst doing this. Anyway, finally the real cam is fitting fine and turns easily enough. This method works!