Going to take a crack at Index racing next year

33IMP said
Made mine from 1/4 aluminum angle. Forgot to mention: drilled a hole through the angle and the carb base plate for a roll pin. It won't loosen the hold down bolt that way.....
Also, I drilled the hole and tapped it at an angle, so it was 90° to the carb throttle linkage.
(Had a low 11s car I wanted to run at the bottom of a 12 sec bracket. I like to chase.)

Here is a picture of the Moroso one I use however mine is modified , the car is in my trailer I will take a picture of my set up for you tomorrow