Tunnel ram or no tunnel ram...

From the top to the bottom of your emulsion stack (1 being the top) this is where I would start but first let me say that there is enough wrong (compared to the way I do it) that you just need to start over so for your emulsion stack I would use:

1. Blank
2. .026
3. Blank
4. .026
5. Blank

Thats all you need for emulsion.

Your Idle Feed Restricters need to go in the lower hole and I’d start at .026 and start with .066-.068 Idle Air Bleeds. You need to get some fuel out of the idle circuit or you need to add air. As you’ve already seen, it takes a TON of air to change the ratio. Think AFR. It takes way more air to make a move than fuel, whether you are trying to go leaner or richer. So get some fuel out of it and then when it’s close enough you can use the IAB to dial it in.

With your boosters you should be somewhere around a 76-78 main jet and a Power Valve Channel Restricter of .062-.066 and your secondary main jets should be somewhere around 84-88. I’d start at your .028 MAB and see what that looks like.

I think you’ll need a power valve opening of 8.5-9.5. I don’t think it will need to open it any later than that.
So you would use even smaller IFR than I already have? Why is that? I'm pretty sure Im in the transfer slot when my problems occur.
I can plug the lowest hole easily as a temporary sollution. What will this cause for me? I'm trying to understand the way this works...