Fresh 904 skips 2nd gear

First Tqflite 904 rebuild in 30 years.
I got a good kit with alto frictions and kyolene steels. All new seals, all measurements fell within spec.

There was already a proven TF-2 kit in the valvebody which remained intact.

I added a CRT multi spring to the front as the big anti wound coil was weak. Also added new rear and middle aluminum servos. Front band apply servo was left alone.

First drive attempt first gear wound up to about 3k...and straight to 3rd. Only went a couple miles....different throttle positions were tried...no change.

I turned around and got about a block from the house (fully warmed up now) and got 1-2, and 2-3 shifts pulling away from the light. I went another block and it wouldnt do it again.

I readjusted the front band...same result.

Next attempt I only backed off 1 turn from 78 inlbs. Nope.

Left it at 78 inlbs...seems better..but will wear front band quickly.

Thinking I should take a few springs out of the CRT unit.

Thoughts?

And many thanks.