Edelbrock RPM Airgap Bolt Hole

Edelbrock said that they were getting a lot of complaints from folks not being able to get their stock intake bolts in the holes is the reason they started working out some bolt holes. When they say 'stock', I assume it's the six sided hex bolts. I can see that being a real problem from 74Scooters picture. Poor QA/QC in my humble opinion.

This is the 21st century, the age of computers and they say we have a rover on Mars. Can't the engineers make an adjustment to the casting mold and just fix the issue?

Rumblefish, I have thought about sending it back to Edelbrock but I suspect I would just get another one just like it or worse. Maybe just not enough of us mopar folks addressing the issue with them. Think I may measure the recess depth/diameter and see if I can find a flat washer that will fill that recess and bring it back up to level of casting, then add one more to get to height of other bolts/washers. Will also have to be able to use the same diameter washers on all of the other holes so they are all the same size. If I can't make that work and look decent, definitely sending it back to Edelbrock even if it is at my expense.