Finally finished my leafspring relocation/torqueboxes and frame ties

I needed something to make sure the area was perfectly flat and needed something to get a good weld to.
So i took a 16ga steel and cut and bent a lip on either side.I made it to fit inside the original frame rail. I drilled holes in the frame and plug welded the plate 1/8inch up inside the rail. Than took some 1/2 in square stock and welded it to that with stitch welds.
The bace was just so i could weld the absolute **** out of the 1/4 inch steel i made the leaf perches to and know that it will hold and be level. A bit overkill but i like it.