Come on Edelbrock. Get your act together.

pittsburghracer said
Ok guys what would you do. This is where the port should be but because the top was milled off you can see how much material is left. I wont rely on that to seal and have a couple ideas. What would you guys do. The thin area is the top of the port. The best area to have.

View attachment 1716031468

View attachment 1716031469

That hurts more than the fubar opening..

Just a blind guess: angle mill or just mill the head to try and give you meat to raise the intake in relation to the head?

Gotta be better than welding another 5lbs of alloy over the runners..