Come on Edelbrock. Get your act together.

pittsburghracer said
Ok guys what would you do. This is where the port should be but because the top was milled off you can see how much material is left. I wont rely on that to seal and have a couple ideas. What would you guys do. The thin area is the top of the port. The best area to have.

View attachment 1716031468

View attachment 1716031469

Do I understand correctly; you have the heads too, and that is where the gasket needs to be to line up? Is the head opening that big too?

I am guessing you’ll be welding the intake or milling the deck surface of the head to lower the top of the port?