63 Dart ignition issue

I am in the process of reassembly of my 63 Dart and finally got to the point of firing it up for the first time in 3 years but ran into a slight issue.

When I start it starts and runs good but as soon as I release the key to run it shuts off. If I hold it just past run towards start but not enough to engage the starter it will stay running. I rang out the ignition and it seems fine. (Even had a spare to double check. Both work the same). With key on I have power at bat acc, and ign1. When I turn to run I have power at bat, acc, ign2 and start.

It worked fine before disassembly. Does anyone have a wiring diagram of the ignition circuit? I have a service manual but it shows nothing for wiring. I am guessing either when I replaced the bulkhead connectors or block I put a wire in the wrong spot (was really careful so I'm doubtful on that) or something outside failed or got plugged in wrong.

I would like to trace back the wiring first to make sure it's all plugged in correctly before trying to test components or replacing.

Thanks