Floor pan replacement on jack stands

In the factory service manual there are lifting locations.

The fronts sound like the right place.

The rears, not sure where you are talking about. But IIRC the rear location is Infront of the front spring hanger.

Assuming your floor is flat I would get measurements from the same points to ground from both sides to be sure the car is not twisted. And also x measurements to be sure it is not squed.


As mentioned if the doors shut good and the gaps look good you are probably good to go.

Side note... My 67 convertible the doors shut fine, but with the top up they are a bit tight. And if I raise one wheel they are a bit of a bear to close.