Pictures of Bouchillon with two barrel carb
Ok 1.020 that way to bottom. original 1.200 .extend flat steel weld drill hole at about 1. 2500, be just about right. Stupid question, why not use orignal shaft point to pull with. Run cable forward in front of carb and loop back to rear of tranny. Would a change of direction be necessary?
Ok 1.020 that way to bottom. original 1.200 .extend flat steel weld drill hole at about 1. 2500, be just about right. Stupid question, why not use orignal shaft point to pull with. Run cable forward in front of carb and loop back to rear of tranny. Would a change of direction be necessary?
