Reground Cam
I had one reground by Oregon Cam Grinding about three years ago. I would need to dig out my receipt to check cost. I "think" it was around $260. Damn shipping to him was a bunch. Can't remember how much but it was a lot. I packed the hell out of it, lol.
@RustyRatRod suggested the #1280 grind and Ken confirmed it was a great choice for my build. Cam sheet is below.
I tore a 2001 5.9 down to the short block and a a machine shop finish the tear down, hot tank it, then install new main, rod, and cam bearings. I built it from there using the reground Cam (,215/.223 @ .050, .517 @1.6), original lifters, Comp Cams 1.6 roller rockers, Edelbrock 2.02 heads, Air Gap intake, and played with several carbs until settling on an AVS2 850, Doug's headers, and a PTC 9.5" converter. Runs strong!!
I had one reground by Oregon Cam Grinding about three years ago. I would need to dig out my receipt to check cost. I "think" it was around $260. Damn shipping to him was a bunch. Can't remember how much but it was a lot. I packed the hell out of it, lol.
@RustyRatRod suggested the #1280 grind and Ken confirmed it was a great choice for my build. Cam sheet is below.
I tore a 2001 5.9 down to the short block and a a machine shop finish the tear down, hot tank it, then install new main, rod, and cam bearings. I built it from there using the reground Cam (,215/.223 @ .050, .517 @1.6), original lifters, Comp Cams 1.6 roller rockers, Edelbrock 2.02 heads, Air Gap intake, and played with several carbs until settling on an AVS2 850, Doug's headers, and a PTC 9.5" converter. Runs strong!!
