Ultrasonic cleaner for carbs?
I use distilled Water and Pine-Sol.
2 gallons water to 1 ounce of Pine-Sol.
Get water hot with the Ultrasonic cleaner then put the carb in.
Don't put your hands In the solution with the Ultrasonic Running, it's hard on your bones.
Do it outside or your whole garage will smell like Pine-Sol.
__________
Do 15 minutes at a time and keep an eye on it. Old aluminum carb in too long and they start turning dark gray / black.
Have to help some of the tough spots along with little scrapers and brushes between soaks.
It takes care, blow compressed air through all the small holes, if they are plugged get the little wires out, then a final soak.
These are the newer Shinny finish Edelbrocks ^^^. They clean up easy compared to the non coated early aluminum carbs.
@rumblefish360 is the thermal quad expert.
☆☆☆☆☆
I use distilled Water and Pine-Sol.
2 gallons water to 1 ounce of Pine-Sol.
Get water hot with the Ultrasonic cleaner then put the carb in.
Don't put your hands In the solution with the Ultrasonic Running, it's hard on your bones.
Do it outside or your whole garage will smell like Pine-Sol.
__________
Do 15 minutes at a time and keep an eye on it. Old aluminum carb in too long and they start turning dark gray / black.
Have to help some of the tough spots along with little scrapers and brushes between soaks.
It takes care, blow compressed air through all the small holes, if they are plugged get the little wires out, then a final soak.
These are the newer Shinny finish Edelbrocks ^^^. They clean up easy compared to the non coated early aluminum carbs.
@rumblefish360 is the thermal quad expert.
☆☆☆☆☆
