Summit brand smallblock rods Any good

I put Scat rods in my 273. It was cheaper to use them than it was to have my old ones reworked. My machinist checked the Scats and they all weighed exactly the same. Big ends were all exactly the same weight and so were all of the little ends.

To the OP @318boy , if you use the aftermarket rods, look at the big end and see if they are chamfered only on one side. If so, that chamfer needs to be turned towards the outside of the rod journal on each side. Another way of saying that so it might make sense is the flat sides need to be facing each other in the middle. For example, cylinder 1 rod chamfer faces the front of the engine and cylinder 2 faces the rear of the engine.