What could cause this? 360 problems ####update####
1st pic is #6 lifters. 2nd pic is #1 lifters. The lifters are too far down to put a straight edge across so i measured from the top of the lifter to the top of the lifter bore. .07, .06, .06, and .06 were the measurement. does this look right?
1st pic is #6 lifters. 2nd pic is #1 lifters. The lifters are too far down to put a straight edge across so i measured from the top of the lifter to the top of the lifter bore. .07, .06, .06, and .06 were the measurement. does this look right?
