EXTENDED STORAGE OF A REBUILT 727

Thanks for everyone's input. I made an insert out of aluminum the exact dimensions as the torque converter snout, and machined the pump slots into it. I then made an insert out of a hockey puck that pressed into the aluminum insert that had a friction fit with the input shaft splines. This will keep gravity from allowing it fall off in the vertical position. The seal and all of the splines of the input, and reaction shaft have been generously lubed with Vaseline, and the outer tip of the insert was sealed with Gorilla tape. There should be no moisture getting in from the pump side. I used a driveshaft yoke to seal the other end. I am going to store it vertically on a wheeled dolly in an area that is heated in the winter. I hope this will suffice? I don't want any issues! Thanks again all :thumbsup: