Torsion Bar Retaining Clips
(Obviously don't go through the tortion bar and keep it away from the tortion bar enough to mimic the amount of distance the origional clip had to the end of the t bar)
- Get another receiver and have it welded into the cross member
- Grind the end flat, maybe a few thousandths below the OEM clip slots. Cut a piece off of a good one and butt weld the two pieces together.
- Drill a hole through the remaning receiver and put a roll pin in it.
(Obviously don't go through the tortion bar and keep it away from the tortion bar enough to mimic the amount of distance the origional clip had to the end of the t bar)
