Suggestions for new design Aluminum Mopar SB clean slate (kind of) cylinder heads

bigfoot said

The point is with a few changes in the casting, it will work fine as a street head and crate engine head, AND hopefully provide a lower cost casting for the guys wanting to build a 650hp and up engine. Thats where there is a huge hole in the small mopar head market.

Click to expand...

That would be nice but wouldn't say it's a huge market 600+ hp sbm, I say 500-550 hp with 10:1 cr 235-245 cam etc.. and for a good chunk of change under Edelbrock, Trick Flow prices is where there's a potential market , Magnum head design is a good choice since it can easily go on both LA Magnum short blocks thats where speedmaster fell short if they were only gonna sell one platform should of been magnum.
Be nice if 290 cfm was as cast with enough meat to grow some.