Turn a small drill press into a Bore/ Hone. Bolt it to the top of your engine block & do your own machining .

Jessearent said
Will keep you all posted when I figure out how I can bore with my "drill press" it's not impossible, and it will be safe for sure, So this " bag of rocks" must teach the teachers.

Jessearent said
My bore hone will have a solid shank and harder than average stones from Russia that easily cut/grind metal. Kitted for a 3 cuts. Course, medium and the final hone.

WTF??? On hard surfaces you use a SOFT stone to hone and of soft surfaces you use a HARD stone.

If you are honing a SBC you use a hard stone because that junk is so soft.

If you are honing a quality aftermarket block or sleeve you need soft stones.

You aren’t teaching any machinists on here a damned thing. You are just making an *** of yourself and your ignorance is appalling.