Lower control arm bushing slides onto pin

So, I picked up the NAPA bushing and guess what... Yup, no good. I brought it back and add they are a major warehouse location they had 7 more out back. He brought them all out and were starting checking. The first 2 we grabbed were good. Got lucky to get a bad one right off

I grabbed one and installed it. The one thing I did notice was it pressed on the pin nice and it did press into the control arm ok but the top of the bushing was very slightly bell shaped, not the sharp bend like usual. Only thing this did was bulge the rubber a little when I fully seated the bushing as it was compressor the rubber a bit. No big deal as the pin didn't move and it pivots as it should.

Finally moving forward again. Still not overly impressed with the bushing quality overall but it fits