hello from New Zealand, 18 spline head ache a833.

abdywgn said
the shaft on the left is 6-3/4" from the thin machined flange right above where the snap ring goes. it is a homemade slick-shift with every other tooth ground off.
the other one is a Liberty prepped shaft with their ring welded on and it is 7" long. the end appears to be 3/4". best I can do with a tape measure. there are also
12 weld beads holding the ring on.

View attachment 1716100569

any photos are welcome and appreciated

perfect perfect, very similar to mine, my end just need an extra inch and id would be sorted

input new (5).jpg