340 Stroker: experiences with parts

Scat Balanced 4" kit. Cast crank will be fine under 500 hp on the street. Molnar is a good brand too.

I think Edelbrock head would be fine. But with Trickflows you get better quality and flow. In your situation where labor might be expensive to double check a set of Edelbrock heads, the Trickflows might be a safer bet even though they are overkill.

What octane rating gas do you have there? That will determine static compression. Then you have to pick a cylinder head. After those two items, you can pick the rotating stroker kit with the piston that closest matches the compression you want. You'll be using a compression calculator that you plug in the head cc, compressed gasket thickness, piston dish, pin height, stroke, bore, etc, etc.

Then go to Bullet for a custom cam before you finally buy the kit. You might make adjustments on the kit per their recommendations. Discuss the need for roller rocker with them.

Comp cam has a good steel roller rockers with longevity.

Intake would be a Edelbrock Air Gap dual plane intake. I would not mess with that Offy Spider deal.

That's it. Keep it simple.