I have a set of Hooker 5303 1-7/8 headers on my small block A Body drag car. The left side tubes got bent up from getting snagged on the trailer. I'd like to replace these tubes if anyone has them but since that's a slim chance, I'm looking into repairing these. I'd like to hear any tips and tricks on repairing Header tubes.
If you have a stud welder for dent removal, weld a couple studs on where you think will do the best for pulling the dent. After you get the studs on heat it with a torch, then grind the studs off....very very simple repair.
