Bushing or not?

Thanks for the reply cfd244, I'm pretty sure it's original, it was a factory 3 spd on the floor which we changed to 4 spd but I'm pretty sure the inside had been untouched but either way it's still a duster column that should except this bearing I realize it didn't have a bearing from the factory just the little white bushing but this is supposed to be a upgrade to support the shaft better i just need to know what to remove to make it fit? Like I said there is essentially 4 parts, two d shaped rods that slide into one another and two approximately 2 inch tube that slide together and they all essentially slide into each other, one either needs to be removed or shortened I think? I'm sure someone has done this before?