Edelbrock springs 1406 and 1405

Thanks Rob, yes, 1406 to utilize choke if need be, but it's not hooked up. I know I squared up the transfer slots on both, prior to install, but there has been some slight adjusting on the 1406 since installing.
Is that fuel by the air valve weights normal?
I have a set of rods to lean the 1405/front carb
The front carburetor is where the rich problem is. If you have the air screws turned all the way in and the car still runs, that means that front carburetor is pulling fuel from "somewhere" at idle. Have you had them off to check that the throttle blades only have enough of the transfer slots exposed to make them square? That would be one thing that could do it. That front carburetor would be suspect to me at this point.

Are we messing with two DIFFERENT carburetors here? Is the front a 1405 and the rear a 1406?