Torsion bar install question

After a complete tear down I'm putting the front suspension back together. I was planning to install the torsion bars with only the lca's and strut rods in place loosely. No other suspension pieces (uca's, spindles, lower ball joints) are installed as of yet.

I've searched a bunch of threads and most say that the lca's should be hanging down as far as possible and hitting the K frame.

The strut rods are holding the lca's up a bit from the K. To align the T bar flats with the lca socket I had to pull the lca down a little by hand.

I'm wondering if I'm off by one flat with the strut rod holding the lca from hanging down far enough?